Cushman Hauler 4x4 Crew Diesel 2019, Operator'S Manual

Page: 47 / 72

45
4. Install the wheel and tighten the
wheel nuts in 25 ft-lb increments to a
final torque of 100 ft-lb.

NOTE: Whenever the wheels are
removed and installed onto the hub
and the lug nuts are tightened, refer
to the Maintenance Schedule found
on page 39 to identify the appropri-
ate service interval requiring the
tightening of the lug nuts.
Fuel Hoses
Inspect the fuel hoses. Damage from
aging may not always be visible.
Protective Rubber
Boots
The protective boots should be inspected
periodically according to the Mainte-
nance Schedule.
Ball Joint Boots (Upper
and Lower/Right and Left)
MOD094A
1. Secure the vehicle on a support stand
to elevate the front wheels.
2. Remove both front wheels.
3. Inspect the four ball joint boots for
cracks, tears, or perforations.
4. Check the ball joint for free-play by
grasping the steering knuckle and
turning it from side to side and up
and down.
5. If boot damage is present or ball
joint free-play seems excessive, con-
tact an authorized Cushman dealer
for service.
Tie Rod Boots (Inner and
Outer/Right and Left)
MOD071B
1. Secure the vehicle on a support stand
to elevate the front wheels.
2. Remove both front wheels.
3. Inspect the four tie rod boots for
cracks, tears, or perforations.
4. Check the tie rod end free-play by
grasping the tie rod near the end and
attempting to move it up and down.
5. If boot damage is present or tie rod
end free-play seems excessive, con-
tact an authorized Cushman dealer
for service.
Drive Axle Boots
CC793
1. Inspect all drive axle boots for
cracks, tears, or perforations.
2. If boot damage is present, contact an
authorized Cushman dealer for ser-
vice.
Rear Knuckle Grease
Zerks
There are four grease Zerk fittings on the
vehicle — two on each rear knuckle.
They can be accessed from the rear of the
vehicle.