MA5V
5
Step #5 Assemble and Install 20-Meter
Resonator Coil and X-Hat:
Find the 20-Meter resonator assembly (MA5VRC ) and two 3/16”
OD x 12” center-drilled X-hat rods (XHR12). Also, find two 1” screws
(29), two lockwashers (41) and two nuts (11).
Install X-Hat rods as shown in
Photo-16
. Note that each pair of mounting
holes are “step drilled” (one hole is larger than the other). Place the hat
rod over the larger hole to lock it into position and secure in place with
a screw, lockwasher, and nut.
Find four flexible vinyl caps (68) and a small worm clamp (07). Install
a cap on the tip of each X-Hat rod. Also, install the small worm clamp
on the top section of the resonator
(Photo-17)
.
Find a large worm clamp (411). Slide clamp on the slotted end of the
1” element tube and install coil assembly for an extension length of
2-1/2”
(Photo-18)
.
Step #6 Install 10/12-Meter and 15/17-
Meter Resonator Assemblies:
Find the 10/12-Meter resonator assembly (MA5VRA) and the
15/17-Meter resonator assembly (MA5VRB). Also find four small
worm clamps (07) and two nuts (11).
Locate the lower of the two resonator-mounting holes on upper
element tube MA5VBD (21-1/2” below top lip of tube). Mount the
10/12-Meter coil assembly — as shown in
Photo -19
— using a nut
(resonators are labeled by band). Install a worm clamp loosely on
each end.
In similar fashion, locate the higher of the two resonator-mounting
holes (6-1/2” below top lip of tube), and mount the 15/17-Meter
resonator coil assembly. Install worm clamps.
Photo-16
Photo-17
Photo-19
Photo-18
11
2 PLACES
XHR12
2 PLACES
41
2 PLACES
29
2 PLACES
68
4 PLACES
07
MA5VRA
07
4 PLACES
11
411
RC MA5VRC Resonator
assembly
20 Meter
1
12
HXR12
X-hat rod
12”
2
29 010229
RH
machine screw
#8-32 x 1”
2
41
011941
Split lock washer
#8-32
6
11
010011
Hex nut
#8-32
4
68
053368
Vinyl caps
.156” ID x 1/4”
4
07
030407
Small worm clamp
-------
5
411
030411
Large worm clamp
-------
1
RA MA5VRA
Resonator assembly 10/12 meter
1
RB MA5VRB
Resonator assembly 15/17 meter
1
KEY P/N DISPLAY
DESC
SIZE
QTY
