CUSHCRAFT A50-3S Assembly And Installation Manual Download Page 7

A50-3S

115 050115

CONNECTOR

1

BOOT

116 240116

SILICONE

1

PACKAGE

KEY      P/N                 DISPLAY                     DESC                     SIZE             QTY

#5 - FEEDLINE ASSEMBLY

Before attaching the feedline permanently, tune the antenna as outlined
on page 2.  The antenna is designed for use with 50 Ohm coaxial cable
terminated with a PL-259 connector.  Any length of feedline can be used
with your A50-3S.  The shortest length of cable will have the least loss.
A connector boot is included for use with your new antenna.  (Figure F)
Slide the boot over the cable before attaching your PL-259.  Coat only
the outside connector threads and shell with silicone grease.  

Do not

coat the center pin or receptacle.  After the PL-259 is firmly screwed on
to the antenna connector, slide the vinyl boot over the connector and
against the mast bracket.  When taping the feedline to the mast it's a
good idea to form a drip loop in the coax to help protect the connector
from water damage (figure G).

6

FIGURE G

cushcraft

COAT WITH SILICONE GREASE

(DO NOT coat the center pin or socket!)

cushcraft

DRIP LOOP

BOOM

SILICONE GREASE

cushcraft

FIGURE F

SPECIFICATIONS

Frequency, MHz
Number Elements
Forward Gain
Front to Back Ratio
SWR Typical
2:1 Bandwidth MHz
Power, Watts PEP
Boom Length
Longest Element
Turning Radius
Mast Size Range
Wind Surface Area
Weight

50-54
3
8 dBd
20 dB
1.2:1
>1
1000
6 ft. (1.8 m)
117 in. (300 cm)
6 ft. (1.8 m)
1.5-2 in. (3.8-5.1cm)
1.80 ft

2

. (0.17 m

2

)

7 lb. (3.2 kg)

48 PERIMETER ROAD, MANCHESTER, NH 03108 • 603-627-7877 / FAX 603-627-1764

COMMUNICATIONS  ANTENNAS

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

LIMITED WARRANTY

Cushcraft Corporation, P.O. Box 4680, Manchester, New Hampshire 03108,  warrants to the original consumer purchaser for one year from date of purchase that each Cushcraft antenna is free
of defects in material or workmanship.  If, in the judgement of Cushcraft, any such antenna is defective, then Cushcraft Corporation will, at its option, repair or replace the antenna at its expense
within thirty days of the date the antenna is returned (at purchasers expense) to Cushcraft or one of its authorized representatives.  This warranty is in lieu of all other expressed warranties, any
implied warranty is limited in duration to one year.  Cushcraft  Corporation shall not be liable for any incidental or consequential damages which may result from a defect.  Some states do not allow
limitations on how long an implied warranty lasts or exclusions or limitations of incidental or consequential damages, so the above limitation and exclusion may not apply to you.  This warranty
gives you specific legal rights, and you may also have other rights which vary from state to state.  This  warranty does not extend to any products which have been subject to misuse, neglect, accident
or improper installation.  Any repairs or alterations outside of the Cushcraft factory will nullify this warranty.

Summary of Contents for A50-3S








Reviews: