FL
FEEDLINE
1
HARNESS
116
240116
SILICONE
1
PACKAGE
5
A270-6S
#5 - MAST MOUNT
#4 - FEEDLINE HARNESS
Slide back all four vinyl boots on the feedline harness (FL) to expose
the male PL-259 coaxial connectors. Unthread both connectors from
the coaxial T-connector. Apply silicone grease (116) to the outer
threads of the in-line connectors on the T-connector and re-attach
both coaxial male connectors to the T-connector. Apply silicone
grease to the outer shells of both male PL-259 connectors. Do not
coat the center pin or socket of the PL-259! Slide both vinyl boots
over the connectors until they butt against the T-connector to create
a waterproof seal. Coat the outer threads of both Reddi-Match
connectors located on dipoles EC and ED. Do not coat the center
pin or socket of the PL-259! Thread on both free ends of the feedline
harness (FL). Note that both lengths of cable are equal. Coat outer
shells of connectors with silicone grease (116). Slide both vinyl boots
over the PL-259 male connectors. Make sure the boots butt against
the connector brackets. Tape the feedline harness as shown (fig. E).
KEY P/N DISPLAY DESC SIZE QTY
FIGURE E
FIGURE F
Mount the antenna to your mast using the U-bolt bracket (32) and the hardware provided per figure E. When you tighten the U-bolt make sure not
to crush the boom. Affix the warning label (326) to the boom. See "MOUNTING" on page 1 concerning orientation of mast mount, elements and
Reddi-Match.
32
190032
U-BOLT
3-5/8 x 2-1/2
1
BRACKET
(9.2 x 6.3 cm)
33
190033
BACKING
3-1/2"
1
PLATE
(8.9 cm)
118
010118
SS HEX
5/16"
2
NUT
(.8 cm)
119
010119
SS LOCK
5/16"
2
WASHER
(.8 cm)
326
290326
DANGER
1
LABEL
405
010405
SS
5/16"x 4-1/2" x 2-7/16" 1
U-BOLT
(.8 x 11.4 x 6.2 cm)
KEY P/N DISPLAY DESC SIZE QTY
Back
FL
FL
Vinyl
Boot
Connector
Bracket
Tape
T-Connector
ED
EC
EB
EA
32
405
61
326
119
118
33
119
118
COAT WITH SILICONE GREASE
DO NOT coat the center pin or socket!
cushcraft
SILICONE GREASE
