![background image](http://html1.mh-extra.com/html/curtis/tc595/tc595_owners-manual_2699576038.webp)
NOTE:
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
1. Reorient or relocate the receiving ANTENNA.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved in writing by
may void
the user’s authority to operate this equipment.
Some cordless telephones operate at frequencies that may cause interference to nearby
TVs and VCRs. To minimize or prevent such interference, the base of the cordless
phone should not be placed near or on top of a TV or VCR. If interference is
experienced, moving the cordless telephone farther away from the TV or VCR will often
reduce or eliminate the interference.
If trouble is experienced with this equipment, for repair or warranty information, please
contact service center at the below. If the equipment is causing harm to the telephone
network, the telephone company may request that you disconnect the equipment until the
problem is resolved.
Service can be obtained at:
U.S.A
C.I. Service Dept.
181 Cooper Avenue
Unit 104
Tonawanda, N.Y.
14150
AC ADAPTOR: Use only with class 2 Power Source, 9V DC output, 300mA,
center pin positive for BASE UNIT and 9V DC output, 100mA, center pin
positive for CHARGER UNIT
FCC Requirements
Summary of Contents for TC595
Page 6: ...HANDSET Controls 5...