Curtis GEMINI 200R, Service Manual

Page: 3 / 16

GEMINI 200R COFFEE BREWING SYSTEM
Read and follow Setup Instructions before attempting to use this brewer. This manual should
cover most questions you may have about the Gemini 200R. However, if you need additional
information, you can call our factory Technical Service Department at (323) 269-8121.
When you encounter index numbers in parentheses, following parts mentioned, they refer to the
index numbers on the parts list, pages 7 to 10.
SETUP INSTRUCTIONS
1. Carefully unpack shipping carton. Check for any damage.
2. Attach the four adjustable legs, threading them into tapped holes underneath the brewer.
Level the machine.
3. Rinse out the brew cone and satellite with water.
4. Hookup electrical and plumbing to comply with all local building codes.
A . Remove the panel in back of the machine to gain access to the wiring for electrical
hook-up (see fig. 1 to wire power to the brewer).
B. Thread the 3/8" compression fitting into the water inlet valve behind the brewer. Run a
3/8" copper tubing water line with a 3/8" flare nut to this fitting. It is recommended
that a water shut off valve be installed on the incoming water line to the brewer.
IMPORTANT: Brewer must be connected to COLD water line. Water inlet valves are not
rated for hot water.
5. Remove the top cover (1) by loosening four screws.
6. Make sure the thermostat (56) is turned OFF (knob turned all the way counterclockwise),
otherwise the heating elements will be damaged if the tank is not filled with water.
7. Open water supply valve.
8. Switch power on at the power switch (45) behind the brewer. This will activate the com-
ponents in the brewer. Water will now automatically start filling the heating tank and will
stop once the water level reaches the probe tip (78).
9. Turn the thermostat ON, by turning knob fully clockwise. Replace top cover.
10. Turn ON the ON/OFF switch (30), located on the front panel.
11. Place Satellite server on warmer deck.
12. Push ON warmer switch (28) to preheat the Satellite server. Before brewing coffee, the
Satellite servers must be preheated for ten minutes.
13. Allow ten minutes for the water in the tank to reach full temperature. After the initial heat
up, temperature recovery is very rapid. You can brew up to two 24-cup cycles before you
must allow time for temperature recovery between brews.
IMPORTANT: Never brew coffee into a cold Satellite. Doing so will result in a lower coffee
serving temperature.
1