Regular maintenance is essential in keeping your GEMINI system looking and working like new.
1. Remove the sprayhead (index Nº 14) from brewer and clean it once a week or more often in heavy lime areas.
2. Clean faucet seat cups on the GEM-3 Satellite twice a week and replace when cracked or leaking.
3. Remove hot water spout aerator from the hot water spout and clean it at least once a week.
4. Periodic temperature checks in the water tank. If too low, thermostat should be adjusted by a qualifi ed technician.
5. The inside of the heating tank should be de-limed at least every six months, especially in heavy lime area.
CARE AND
MAINTENANCE
CAUTION: Do not use
cleansers, bleach liquids,
or powders that contain
chlorine. These products cause
corrosion and pitting to stainless
steel and will void the warranty.
ELECTRICAL SCHEMATIC
WARNING: HOT, allow brew-
cone to drain before removing.
1. Brewer should be ON (Confi rm at rear toggle switch, then press the ON/OFF button).
2. Place an empty Satellite on the warmer deck, under the brewcone. Press the warmer switch to preheat the
Satellite for 10 minutes.
NOTE – The indicator light will come on and remain lit during the brewing cycle to indicate the particular side of
the brewer that is in operation.
6. Press BREW
button to start
brew
cycle.
5. Transfer fi lled
brewcone to
brewer.
3. Place a clean fi lter
into the brewcone.
4. Fill brewcone with
ground
coffee.
BREWING
INSTRUCTIONS
Summary of Contents for Gem-230A
Page 4: ......