Curtis FRIGIDAIRE EFMIS2438, Manual

Page: 5 / 26

Before Using Your Product
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
Model EFMIS2438 : (1) 3 x Flat rack
(2) 1 x Defender
(3) Instruction Manual x 1
Installation of Your Product
INSTALLATION INSTRUCTIONS
This Wine Chiller is designed to be free standing installation only, and should not be
recessed or built-in (Fully recessed).
Place your Wine Chiller on a surface that is strong enough to support it when it is
fully loaded. Allow 5 inches of space between the back and sides of the Wine
Chiller, which allows the proper air circulation to cool the heat sink.
Locate the Wine Chiller away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly. This Wine Chiller uses compressor
refrigeration technology and is not designed for storage in hot areas like garages,
warehouses or outdoors since it is designed to operate at a maximum of 30
degrees below the ambient temperature. Avoid locating the unit in moist areas.
Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do
not under any circumstances cut or remove the three (ground) prong from the
power cord. Any questions concerning power and/or grounding should be directed
toward a certied electrician or an authorized Products service center.
After plugging the Wine Chiller into a wall outlet, allow the unit to cool down for 2-
3 hours before placing any items in the compartment.