INSTALLATION
4 of 7
5.
Changing Fuse (For Gasoline Vehicles
Only):
NOTE; If you have the electric vehicle, skip this section
and proceed to step 6.
5.1
Lift bed or remove seat in order to access
electronic component box.
5.2
Remove the screw the secures the cover to the
electronic component box in the compartment un-
der the driver
’
s seat as shown. Retain the screw
and cover for reinstallation. (Figure 5.2).
5.3
Replace the 10
-
amp fuse (or 7.5 if cab is installed)
with supplied 15
-
amp ATO/ATC fuse. (Figure 5.3)
Reattach the cover onto the electronic component
box. Tighten screw to 17 in
-
lbs (1.9 Nm).
6.
Changing Fuse (For Electric Vehicles
with cab wiper previously installed:
NOTE: If you have the gasoline vehicle or have not
installed the 7.5
-
amp fuse for the cab wiper,
disregard this section.
6.1 Locate the fuse block under the front hood.
Remove 7.5
-
amp fuse installed for cab with 15
-
amp fuse supplied with this kit or removed in Cab
installation. (Figure 6.1)
Front of
Carryall
Figure 5.2
Electronic component box
Fig. 5.3
Front of Cab
Replace 10 (or 7.5) Amp
fuse with 15 Amp fuse
Front of
Carryall
Fig. 6.1
Install15 amp
fuse here
