
Packo manual
2020-7
05
Dynamic load
Before stacking Packos for transport it is important to know what
the maximum stacking load on the bottom container of the stack
is. With transport this stacking load is called dynamic load and can
be found by dividing the admissible static load by a so-called
safety factor. These factors are:
3
for air transport
2
for road transport
1.8
for rail transport
1.3
for maritime transport
The stacking weights mentioned in the table below are indicative
and depend on temperature and time: 5°C is the temperature for
cooled transport, 30°C is the temperature for the average
transport by road or inland waterways and 40°C is the
temperature for transport in warmer surroundings. In case of a
different duration or temperature below 40°C, please choose the
next appropriate column. In case of even higher temperature,
please consider that the dynamic load is at 50°C only 75% of the
last mentioned value and at 60°C only 50%
Temp.
Weeks
4303
4305
4306
4310
4313
4315
4320
4325
5° C
0,5
23
23
22
22
22
100
100
100
1
22
22
21
21
21
92
92
92
3
20
20
19
19
19
77
77
77
5
18
18
17
17
17
73
73
73
30° C
0,5
16
16
15
15
15
48
48
48
1
15
15
14
14
14
44
44
44
3
14
14
13
13
13
38
38
38
5
13
13
12
12
12
35
35
35
40° C
0,5
12
12
11
11
11
34
34
34
1
10
10
9
9
9
33
33
33
3
9
9
8
8
8
28
28
28
Attention!
The weights mentioned in the table have been
established after simulation and can only serve as indications.
CurTec recommends users to perform tests at all times.
The table allows you to calculate the number of containers that
can be stacked: Reduce the stacking weight mentioned with the
relevant share of the weight of intermediate layers and divide by
the weight of the container with content. This number, with a
figure after the decimal point lower than 8, rounded down is the
total amount of containers that can be stacked on the lowest
container of a stack.
Summary of Contents for Packo
Page 1: ......