A
B
C
D
E
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2 - Toyota Tacoma
Open the vehicle tailgate. Remove the 10mm screws holding
the vehicle taillights in place and remove the taillights (A).
Step 2 - Toyota T-100
The wiring harness will have connection points
on the driver and passenger side of the frame.
Step 3
The connectors will be similar to those on the T-connector
harness. Separate the connectors from the taillight housing
taking care not to damage the locking tabs (B).
Step 4
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place (C).
Step 5 - Toyota Tacoma
Route the custom wiring harness end with the green wire to
the passenger side out through the hole between the vehicle
bumper and body (D). Repeat step 4 on the passenger side
using the harness end with the green wire.
Step 5 - Toyota T-100
Route the custom wiring harness end with the green wire to the
passenger side. Repeat step 4 on the passenger side using the
harness end with the green wire.
WARNING:
Check for miscellaneous items that may
be hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the
ring terminal and provided screw.
Step 7
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape (E).
Step 8
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust cover
to help prevent corrosion.
INSTALLATION / SAFETY INSTRUCTIONS
55513-INS-RB • PAGE 2