CURTMFG.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
70108-INS-RC
•
PAGE 7
Step 12
Use a utility knife to cut off the driver-side
temperature sensor bracket from the front
plastic trim piece.
Drill a 1/4" hole in the bracket and reinstall
the bracket on the upper mounting hole on
the driver side of the plastic trim piece so
the sensor will point forward.
Attach the sensor clip and plastic trim piece
with the factory push pin for this location and
reinstall the front plastic trim piece on the
grille, using the remaining factory push pins.
Step 13
Reinstall the windshield washer reservoir,
using the previously removed hardware.
For the bottom-most rearward bolt, use
the supplied M6 hex head cap screw (#7)
and M6 flat washer (#6) to attach the fluid
reservoir through the base plate to the frame
(the fastener clamps the baseplate between
the reservoir and the frame).
Reconnect the reservoir fluid hoses
and electrical connectors and refill
with windshield washer fluid.