Currys Essentials CGHOBB12, Instruction & Installation Manual

Page: 7 / 24

7
Electricity Failure
If there is an electricity failure, you can still use your hob. Light the burners by holding an ignition source (e.g.
candle lighter) close to the side of the burner and turning the control to the High position to light the gas. The
controls must still be held down for 5 – 10 seconds after the burner has lit. Releasing the controls too soon will
extinguish the flame. Adjust the controls as required.
Flame Failure Safety Feature
The flame supervision device (FSD) probe cuts off the gas supply to the burner if the flame is extinguished.
When lighting the burner, hold down the control for approximately 5 – 10 seconds after the burner has lit.
Releasing the control too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least 90
seconds (to allow the gas to disperse).
If the Burner Does Not Light
If the burner does not light, check that:
• The hob is connected to the electrical supply and the supply is switched on.
• The gas is turned on.
• You have held down the control for at least 5 – 10 seconds after the flame has been lit.
• The ignitors are sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them gently with a
small nylon brush such as a toothbrush as shown below. Ensure the electrical supply has been disconnected
before cleaning.
If the Flame is Irregular
If the flame is yellow or irregular, check that the burner parts, including the burner cap (allow to cool before
touching), are:
• Clean and dry.
• Positioned correctly. See ‘Replacing the Burners’.
• Also see ‘Hints and Tips’.
Ignitor
Flame failure
probe
Burner Cap
Electrode
Burner Ring
* All images are for indication only; please refer to your individual unit for actual item.
To avoid damage to the
ignition circuit NEVER light
the hob when the burners
are not in place.
CGHOBB_W12_IB_120601_Annie(Check).indd 7 12年6月1日 下午5:12