GB-8
INSTALLATION
6. Position the dishwasher next to a water tap
and a drain. Ensure the water inlet and drain
hoses are not kinked or squashed. The unit
must not stand on the mains cable.
INTENS
IVE NO
RMAL E
CONOM
Y RINS
E
RAPID
SOAK
1
2
1
2
3
4
5
6
ON
OFF
START
RESET
PROG
1
2
3
4
5
6
7. Make sure your plumbing is suitable for use
with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using the
new water inlet hose. OLD HOSE SETS MUST
NOT BE RE-USED. The water pressure from
the water mains needs to be at a minimum of
0.04 MPa and a maximum of 1.00MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and then
connect the other end of the hose to
your water mains. Please ensure the black
rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
• Do not bend your drain hose.
safety water supply hose
Connect
to another
appliance
if required.
water mains
Y-Adaptor
(not included)
You may use a Y-adaptor (not included)
For additional water feed for another
appliance, for instance a washing
machine. This is only applicable for cold
water mains. A Y-adaptor is available from
most DIY stores.
CDW60W10_IB_110324.indd 8
24/03/2011 10:27 AM
