Currier Tech IZIP VIA URBANO, Assembly Manual, Page: 8 / 16

Power switch location
Currie Technologies
Technical and Customer Service
1-800-377-4532
Q
Operation
1
2
3
1.
Flip the rear power switch to the ON position, then press to turn on the bicycle.
• After pressing ‘Power’, all eight meter lights will flash in sequence, indicating that the
bike is ready to ride.
2.
The lights indicate remaining charge.
• The battery gauge provides five indications of battery level.
• When the battery is depleted to the point of automatic shutoff, the lowest gauge light
will blink indicating the need to recharge immediately. Of course, the bicycle can still
be ridden while the system is turned off.
• Due to the way the battery gauge measures charge, the indicator lights may fluctuate
while riding based on the motor’s current load.
• The best indication of remaining battery life is to check the battery level gauge LEDs
after reaching cruising speed on a smooth, flat, straight road. This will allow the
battery voltage to stabilize and will give a much more accurate reading.
3.
The button controls motor assist power
• The PAS system provides three assist levels, which can be cycled between using the
‘/-’ button.
• Each level of assist corresponds to a maximum motor speed; at level 3, the motor
runs at full power.
• The system defaults to the lowest assist level at startup.
• The motor will activate when the system senses the rider pedaling. It is not possible
to activate the motor without turning the cranks.
The Via Urbano uses
‘PAS’
Technology:
PAS