11
/16
System Operation Manual - E3 Path+, Venture, Detour
10/29/14
Using the battery
Installing the battery
First, make sure the battery is unlocked. If needed, unlock the battery by turning the key
45° counter-clockwise until it stops.
Then, slide the battery into the rack from the rear; the end of the battery will be flush with
the battery receiver when fully inserted.
Finally, lock the battery in place by turning the key 45° clockwise.
You must lock the battery before riding the bike. If the battery is unlocked, it could
fall out while you ride.
Removing the battery
To remove the battery, first unlock it, then pull it straight out the back of the rack.
Turning the bike on and off
To turn the bike on...
Press the control pad power button (
). The display will initialize, displaying a countdown
on its screen. During this countdown, the software is self-testing and calibrating the bike’s
sensors. While this countdown is shown, do not step on the pedals. The calibration includes
setting a zero-point for the pedal sensors, and any weight on the pedals will disrupt this
process. After the countdown completes, the bike is ready to ride.
To turn the bike off...
Press the control pad power button (
)
two times. A, for 2 seconds each time. After
the first press, the bike will enter assistance level 0, showing ‘0’ on the display’s assist level
indicator (see “Assist levels” on page 12). After the second press, the bike will turn off and
the display screen will go blank, as will the battery power indicator.
