www.current-usa.com
Figure 1
1
Carefully unpack the LED fixture and all components. Ensure your package includes all of the
items listed above. Remove any plastic film or packaging material from fixture and components.
2
Slide the adjustable docking legs on the side of the fixture to match the length of your aquarium.
PAGE 2 of 6
What’s Included
3
Set fixture on your aquarium and adjust docking mounts to ensure a snug fit.
LED Strip
12VDC Transformer
RGBW Controller
4
Connect the 12VDC transformer to the DC plug on the RGBW controller. Plug transformer into a
GFCI protected AC outlet. Ensure transformer is not near water and a drip loop is in place.
Connect the LED strip to the RGBW controller by matching the pins and gently pressing the
connector together. Complete connection by turning cap in a clockwise position.
Mount controller using velcro (included) and attach controller to aquarium stand or a location where
it will not get wet.
5
6
Remove the wireless IR remote from the plastic sleeve and remove the small plastic tab located at
the bottom of the remote. This will connect the battery.
Point the IR remote at the controller and press the red button on the top right corner of the remote.
Light should turn on and is ready to be programmed using the steps on the following pages.
7
8
Installing the Satellite Plus Pro
1 - Satellite Plus Pro LED Strip (either 18", 24", 36" or 48")
2 - Adjustable docking mounts (pre-installed)
1 - Satellite Plus Pro LED controller
1 - Wireless LED controller remote
1 - 12VDC transformer/power adaptor
1 - Velcro for controller
www.current-usa.co m
v.1.0
Wireless LED
Remote
Pro
www.current-usa.co m
03:00
+ -
X
