FIT User’s Installation Guide
FIT RPA 0110
Gold Plated
Constant Tension
Spring -loaded
Terminals
RED
BLACK
Dog Leg
3
With the grille removed, loosen the four (4) Black Dog-Leg screws and the two (2) Silver PPL (Positive Position Lock) LOCK screws a ½ turn
counterclockwise with a #2 Philips screwdriver. Shown are the FIT FastLoc photos.
4
Grab and hold the speaker by the built-in handle as shown. Do Not put fingers into the tweeter in the center
of the speaker.
WARNING! Denting or deforming the tweeter dome will change the acoustics of the speaker.
Insert the connected speaker into the ceiling hole and with a #2 Phillips screwdriver tighten the four (4)
Black Dog-leg screws (clockwise) until the Dog-legs clamp the speaker to the ceiling. If using a power drill
or electric screw gun use the lowest torque setting. Over tightening may cause improper fit of the grille.
Next , while holding the built-in handle Rotate the Tweeter Bridge to the desired degree to allow the Baffle
housing to be angled down.
Now push one side of the Baffle edge to point the speaker to the desired listening area (“Sweet Spot”).
Then with a #2 Phillips screwdriver tighten the two (2) Silver PPL ,Positive Position Lock screws on the
Baffle Housing. This prevents and future movement or vibrations.
WARNING! Do Not Over tighten.
Lastly adjust the Tweeter position to your ear area at the “Sweet Spot” by slighting pushing on the outer
edge of the tweeter with your thumb.
PPL LOCK
Dog-Leg Screws
Baffle Edge
Tweeter Bridge
Tweeter. Push Here
Baffle Housing
Contour Switches
Specifications subject to change without notice.
Strip to
½”
Remove
Outer
Jacket
2”
