Dipole/Bipole Series Ceiling Speaker
User’s Installation Guide
Packaging and Enclosed Parts
Please inspect your pack for damaged or missing parts. Notify your supplier if any discrepancies occur.
There are four (4) parts in the package: Two (2) main speaker housings and two (2) grilles.
Only simple hand tool s are required for assembly and installation.
Required tools: #2 Phillips screwdriver only , if you have new construction brackets previously installed.
Drywall Hand saw if no New Construction Brackets were installed. A saber saw may be required if you are cutting into plywood.
1
Using the supplied Trace Template, place the cutout template against the ceiling and trace
along the inside circle. After using a stud finder to locate beams, it is suggested to cut a
small pilot hole to verify no obstructions, such as pipes or beams, that could hinder the
install.
Carefully cut out the ceiling material along the circle. A drywall saw is perfect for this step.
Hold a box or trash can under your cutting to catch the debris.
NOTE:
A stud finder may be helpful to locate the ceiling beams. You want to layout the hole
to the side of any beams.
Trace Template
CS DB Series 1010 RPA
2
After you have cut your desired hole from the template, locate the speaker wire for that speaker.
Pull enough wire slack down to attach the 2 conductor wire to the gold plated constant tension spring-loaded terminals.
Remove about 2
” of the outer jacket then strip about ½” insulation from each wire and slightly twist the strands to ensure all strands can be inserted into
the hole. Refer to next picture for location of the gold plated constant tension spring-loaded terminals. (See Figure on next page)
Push down on the RED (+) colored Terminal and insert the Red or copper colored conductor all the way up to the insulation into the hole at the bottom of
the terminal. Now release your finger from the terminal . Next do the same to the Black or silver colored conductor and insert into the BLACK (-) colored
Terminal. Make sure there are NO whiskers from the strands that could cause a short. The other end of these wires will be connected to your amplifier or
volume control. (See Figure on next page)
Note:
Sometimes your wire color may be White (+) and Green (-).
You now have a connection with the proper tension for continued operation that will not wiggle out or cause poor connection.
Specifications subject to change without notice.
Layout and Tweeter Orientation
3-D Audio
LCR
TV
Front High
Front High
Bipole
Back Surrounds
Dipole
Ambience
Sub
This speaker is a combo Dipole/Bipole. The function is selected by a switch on the Tweeter Bridge and must be aimed according to the task. See
Section 4 for the description of the Dipole/Bipole functions.
When used as surround Dipole speakers place them equal distance left and right from the listening area and from equal to or slightly behind the listening
area. The tweeters in this application should be aligned parallel to the wall with the arrow facing to the right for correct null ambience.
When used as surround back Bipole speakers place them behind the listening area with the tweeters aimed forward for sound localization.
Null Area
