6
This diagram shows a breakdown of a typical
Cure It roofing installation and its component parts:
1
10
3
4
5
6
7
8
9
11
2
General information
Component Parts of Cure It Roof
1 B260 Raised edge trim
2 D260 Fillet trim
3 C100 Simulated lead flashing
4 A200 Drip edge trim
5 C1 universal external corner
6 2400mm X 600mm X 18mm OSB3 Tongue and Groove decking
7 Cure It laminate comprising of roofing resin and roofing mat
8 Cure It Roofing Topcoat
9 AT 195 External Angle Trim
10 D260 Fillet Trim
11 F300 Flat Flashing
1 C100 Simulated lead flashing.
2 The edge of this roof was masked off before the aggregate
finish was applied.
3 C1 preformed universal external corner.
4 C4 Preformed universal internal corner.
5 A200 drip trim - Laid to facilitate water running off the roof.
6 A slight fall is engineered into the substrate to avoid
standing water.
7 B260 Raised edge trim.
8 D260 - laminated into the substrate, remains unattached
behind the C100 flashing.
Most Cure It roofing installations are for simple domestic flat roofs like the one shown below. Roofs like these incorporate the four most
commonly used trims: A200, B260, C100 & D260. The roof shown below has been finished in a pigmented green topcoat with an exposed
aggregate finish.
2
4
5
6
8
3
7
1
