ENGLISH
16
INSTALLATION
1.
Check that the wall at the preferred place of installation can withstand the weight of the product.
Brick or concrete walls are ideal. The product should be mounted on joists if installed on a
plasterboard wall.
2.
Screw the blind plug (B) and air vent plug
(C) into the two top holes in the vertical
tubes on the rails They can be placed on
either side. Cover the plugs with a cloth to
avoid scratching.
3. Connect the radiator valve pipes (not
supplied) to the two bottom threaded holes.
4.
The wall brackets should be fitted about 10
cm from the edge of the product (1 bracket
at top, 2 brackets at bottom). To simplify
adjustment, place the brackets on the most
convenient crosspiece. Mark the attachment
points with a pencil.
5. Installation on brick or concrete wall.
Drill holes at suitable points with an 8 mm
hammer drill bit. Press the plug (E) into the
hole so that it is flush with the wall. Screw
the long screw (F) into the plug through the
centre of the wall bracket (D) and tighten.
