EN
16
The installation must be carried out by an
electrician or other qualified personnel to
ensure safe use.
USE
HOW TO USE
Power switch
Press the switch
to start the towel rail. Press
once again to switch off.
Timer
Press the button
to set the timer from two
or four hours.
NOTE:
Switch off the towel rail and pull out the plug
when it is not in use.
• The towel rain must be installed at least
60 centimetres from a bath or shower.
• To avoid putting small children at risk
this towel rail should be installed so that
the bottom heated rail is at least 60
centimetres above floor level.
• The towel rail must be installed so that
the power switch or control cannot be
reached by a person in a bathtub or
shower.
SWITCHBOX
1. Fit the switchbox at the bottom on the
right side of the towel rail, as shown in
the diagram.
FIG. 3
2. Remove the side cover.
FIG. 4
3. Pull the power cord through the bottom
of the switchbox, leaving a suitable length
sticking out.
FIG. 5
4. Screw the switchbox firmly onto the
vertical tube on the towel rail.
FIG. 6
Terminals
1. Put the terminal block in the switchbox
and check the markings.
2. Connect the neutral, live and
wires
on the power cord to the corresponding
terminals.
3. Replace the cover and screw tight.
4. Fit the cover plate on the back to conceal
the power cord.
FIG. 7
WARNING!
