3) INSTALLATION
3.1 SETTING THE MACHINE
THE MACHINE CONNECTION AND THE SETTING AT WORK MUST BE MADE BY SKILLED
PERSONNEL.
WARNING:
BOTH THE SYSTEM AND LOCATION WHERE THE EQUIPMENT HAS TO BE SET
MUST COMPLY WITH THE REGULATIONS FOR THE ACCIDENT PREVENTION AND ELECTRICAL
REGULATIONS "CEI" IN FORCE.
THE MANUFACTURER DECLINES ANY AND ALL RESPONSIBILITY FOR DIRECT OR INDIRECT
DAMAGES WHICH MAY ENSUE FOR NON-COMPLIANCE WITH THE ABOVE MENTIONED
REGULATIONS.
SET THE EQUIPMENT ON A WIDE, LEVELLED, DRY AND FIXED FACE, FAR FROM HEAT
SOURCES AND WATER SPRAYS, AND WITH 80 CM. GROUND CLEARANCE.
3.2 FIXING
THE MACHINE HAS 4 ROTATING WHEELS. THE RIGHT
WHEEL AT THE BOTTOM OF THE SWITCH SIDE HAS A
FOOT LEVER. YOU STOP THE WHEEL PUSHING AND
YOU OPEN RAISING THE LEVER. (SEE PHOTO 1)
PHOTO. 1
3.3 ELECTRIC CONNECTIONS
THE EQUIPMENT IS SUPPLIED WITH AN ELECTRIC CABLE TO BE CONNECTED TO A
MAGNETO-THERMIC MAIN SWITCH WHICH STOPS THE MACHINE WHEN THE OPERATOR
COMES IN FORTUITOUS CONTACT WITH THE ROTATING ELEMENTS.
IT IS IMPERATIVE THAT THE EQUIPMENT IS WELL GROUNDED ACCORDING TO THE
REGULATIONS IN FORCE
THE MANUFACTURER DECLINES ANY AND ALL RESPONSIBILITY FOR DIRECT AND INDIRECT
DAMAGES WHICH MAY ENSUE FOR NON-COMPLIANCE WITH THE REGULATIONS IN FORCE.
ALL THE ROUNDERS OF THE SERIES "PAL" ARE MANUFACTURED 3- PHASE V.400/3/50 HZ. OR
SINGLE PHASE V.230/1/50.
WHENEVER THE VOLTAGE DIFFERS FROM THE ABOVE MENTIONED ONES, PLEASE APPLY
TO THE MANUFACTURER, OR THE AUTHORIZED DISTRIBUTOR. (See figures 1 and 2).
FIG. 1 3 PHASE CONNECTION
FIG. 2 SINGLE PHASE CONNECTION
www.linda-lewis.co.uk
5
