info@ cuppaz.com
hotline: 852 2812 0428
6
Protect The Loop from sprays and drips. Water and electricity together can cause
danger of electrocution.
Only connect The Loop to power outlets complying with the requirements of the
law. Make sure that the power supply voltage matches the rating shown on the data
plate, located on the bottom of The Loop.
The surface on which The Loop is installed must be level, solid, stationary and heat
resistant; the bearing surface must not exceed an angle of 2°. No wobbly surfaces
for The Loop!
Do not allow The Loop to be used by children or persons with impaired mental,
physical or sensory faculties or insufficient experience and/or skills, unless they are
under the careful supervision and guidance of a person responsible for their safety.
This is to avoid accidents.
Don
’
t leave The Loop
’
s power cord near hot surfaces, sharp edges or other sharp
objects that can damage it.
Never place your hands inside the capsule compartment as this can cause injury.
Always close the lever of the Loop. Never open the lever while a beverage is being
dispensed.
Never remove machine parts, except those indicated in this guide for daily
maintenance.
Don
’
t insert objects into the openings as this could cause electric shocks. Don
’
t
attempt any operation on The Loop that is not described in this guide. Contact
Cuppaz for support at
or call us at 852 2812 0428.
Don
’
t pull on the power cord to disconnect it. Remove the plug instead to avoid
damaging it.
