background image

Performance Data (RFC-BBS

A

)

Important Notice

Read this Performance Data information and compare the capabilities of this sys-

tem with your actual water treatment needs.  It is recommended that, before pur-

chasing a water treatment system, you have your water supply tested to determine 

your actual water treatment needs.
RFC-BBS

A

 has been tested according to NSF/ANSI 42 for reduction of the substanc-

es listed below. The concentration of the indicated substances in water entering the 

system was reduced to a concentration less than or equal to the permissible limit 

for water leaving the system, as specified in NSF/ANSI 42.

Testing was performed under standard laboratory conditions, actual performance may vary.

Test Conditions

  Flow Rate 

= As noted for each individual cartridge 

Inlet Pressure   = 60 psi (4.14 bar) 

pH   

= 7.5 +/- 1 

Temperature 

= 68°F +/- 5°F  (20°C +/- 2.5°C)

4

RFC-BBS

A

  Substance 

Influent Challenge 

Reduction 

Average 

   

Concentration 

Requirements 

Reduction

  Standard 42

 

  Chlorine 

2.0 mg/L±10% 

50% 

90.3%

  Flow Rate = 3 gpm (11.4 Lpm)  Capacity = 10,000 gallons (37,900 L) or 6 months

Cartridge Selection

 

Select the right cartridge 

(Model #)  R50-BBS

A

   CP5-BBS 

RFC-BBS

A

for your water needs. 
Scale and rust particles 

Coarse sand 

Sand/dirt/silt 

 

Fine dirt/silt/sand 

 

X

Extra fine dirt/silt/sand 

 

Bad taste & odor 

 

 

X

Aesthetic Chlorine: Taste & Odor 

 

 

X

Filter Life (in months)* 

6

(gallons) 

24,000 

12,000 

10,000

Micron Rating (Nominal)† 

50 

25

Service Flow Rate gpm (lpm)** 

10 (37) 

8 (30) 

3 (11)

*NOTE: Filter cartridge life varies depending on usage and water conditions
**NOTE: Flow rates measured at 60 psi (4.1 bar).
†The smaller the micron rating, the smaller the size particle the cartridge will filter. For 
comparison purposes, the human hair has a diameter of approximately 70 microns. 
Particles smaller than 40 microns are not visible with the human eye.

Warranty

This warranty applies to the Filter Housing. It does NOT apply to any disposable filter cartridge 
where life expectancy varies with the water being filtered. This warranty covers defects in material 
and workmanship only for 5 full years from the original date of delivery. Culligan will replace any 
part which in Culligan’s opinion is defective, unless: (1) any part of the unit has been subjected 
to any type of tampering, alteration, or improper use after delivery, or (2) it has been repaired 
by anyone not approved by Culligan. Our Obligation does not include the cost of shipment of 
materials. Culligan is not responsible for damage in transit, and claims for such damage should 
be presented to the carrier by the customer.
This product has been designed solely for use as a housing for a disposable filter cartridge. It is 
NOT warranted against freezing, and neither this product nor its parts is warranted against defects 
or deterioration caused by uses for which this product was not expressly intended.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED 
OR IMPLIED, WHETHER ORAL OR ARISING BY USAGE OF TRADE OR COURSE OF DEALING, 
INCLUDING, WITHOUT LIMITATION, ANY WARRANTIES OF FITNESS OR MERCHANTABILITY. THIS 
WARRANTY IS THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY, IN NO EVENT SHALL CULLIGAN 
BE LIABLE FOR ANY ANTICIPATED OR LOST PROFITS, INCIDENTAL DAMAGES, CONSEQUENTIAL 
DAMAGES, COSTS, TIME CHARGES OR OTHER LOSSES, WHETHER BASED ON BREACH OF  
CONTRACT, TORTIOUS CONDUCT OR ANY OTHER THEORY, INCURRED IN CONNECTION WITH THE 
PURCHASE, INSTALLATION, REPAIR OR OPERATION OF THE OPAQUE FILTER HOUSING. CULLIGAN 
DOES NOT AUTHORIZE ANYONE TO ASSUME FOR IT ANY LIABILITY OR TO MAKE ON ITS BEHALF 
ANY ADDITIONAL WARRANTIES IN CONNECTION WITH THE OPAQUE FILTER HOUSING OR ANY 
PART THEREOF.
For servicing under this warranty, return any defective part to YOUR RETAILER within the 5 year 
period referred to above.
Date installed:

Operating Requirements

  Pressure: 

= 30 - 100 psi (2.07 - 6.9 bar)

  Temperature 

= 40 - 100°F (4.4 - 37.7°C)

  Turbidity 

= 5 NTU Max.

      WARNING:

 Do not use with water that is microbiologically unsafe or of 

unknown quality without adequate disinfection before or after the system.

CAUTION:  

The filters must be protected from freezing. Failure to do so may result 

in the cracking of the filter and water leakage.

Customer Service  M-F 8:00 a.m – 4:30 p.m. CST

 Phone: 1-800-721-7360 Fax: 1-800-721-7390

International: Phone (920) 457-2720 • Fax (920) 457-7366 

 e-mail: [email protected]

Sales & Marketing Correspondence

P.O. Box 1086 • Sheboygan, WI 53082-1086

  Fax (920) 457-7366

e-mail: [email protected]

Culligan International Company

Rosemont, Illinois 60018

www.culligan.com

©2009 Culligan International Company  

03/09   01020704

The RFC-BBS

A

 was tested at NSF International at a flow rate of 3.0 gpm 

to a capacity of 10,000 gal and achieved 90.3% reduction of Aesthetic 
Chlorine Taste and Odor.

The HD-950

A

 housing has been tested and certified by WQA against 

NSF/ANSI Standard 42 for materials safety and structual integrity only.

Summary of Contents for HD-950A

Page 1: ...nants or other substances removed or reduced by the selected cartridge are not necessarily in your water Ask your local water municipality for a copy of their water analysis or have your water tested by a reputable water testing lab After prolonged periods of non use such as during a vacation it is recommended that the system be flushed thoroughly Let water run for 5 6 minutes before using The fil...

Page 2: ...f you are installing on 3 4 inch 19 mm pipe or 1 1 2 inches 38 mm if you are installing on 1 inch 25 mm pipe Mark section of pipe to be removed 5 Using a pipe cutter or hacksaw remove marked section of pipe and thread remaining ends Wrap threads with Teflon tape 6 Align filter assembly with ends of pipe making certain cap opening marked IN is facing the incoming water supply It will be necessary t...

Page 3: ...etails 3 Cartridge Replacement A Turn off water supply to filter Depress red pressure relief button on top of filter Use wrench to unscrew bottom of housing NOTE If turning off water supply to filter will also turn off water supply to the rest of the home be sure to fill a bucket of water first to allow you to clean housing after it has been removed B Locate and remove large O ring wipe clean of l...

Page 4: ... by Culligan Our Obligation does not include the cost of shipment of materials Culligan is not responsible for damage in transit and claims for such damage should be presented to the carrier by the customer This product has been designed solely for use as a housing for a disposable filter cartridge It is NOT warranted against freezing and neither this product nor its parts is warranted against def...

Reviews: