Culina ICONCG60RF, Instruction Manual

Page: 19 / 24

NOTE: This operation must be undertaken within two minutes of switching the
power on at the mains outlet. To change this setting at a later time, switch
off the power at the mains outlet, wait a few seconds, turn on the power and
repeat the above.
General Use
Light On/Off
Use this control to switch the light on independently of the fan motor, it will be
lit red in this mode.
When the fan is in use, and the light is off, the icon will be lit white in this mode,
but will turn red if the light is then switched on.
Fan On/Off and Speed Reduction
Press this icon once to turn on the fan motor at speed 1. All icons will be lit white
and the light icon will be red if already in use.
If the motor is on speed 1, pressing and holding this icon for two seconds will
turn off the fan motor. As above, the light control is independent of this
operation. If the motor is higher than speed 1, this will reduce the fan speed with
each press of the icon.
LED Display
Shows the extraction mode during set up or and the motor speeds from 1-5,
and P for Boost.
Boost Function and Speed Increase
Press this icon once to turn on the fan motor at full power, and P will flash in th e
display.
If the motor is already on speed 1-5, each press of this icon will increase the fan
speed accordingly.
If you press and hold the icon for two seconds, the fan speed will increase to full
power and P will flash in the displa y .
NOTE: Full power or Boost only operates for five minutes maximum t o
conserve energy and the fan speed will automatically drop to speed level
5 after this time.
Timer
When the fan motor is on and the Timer icon is pressed, the icon will be lit red
and the current speed in the display will start to flash .
The chosen speed level will remain in use for five minutes before dropping dow n
to the next lowest speed. This speed will remain in operation for two minutes before
dropping down again. This will be repeated every two minutes unless the speed is
already at level 1 and then the fan will turn off. If the light is already on, this will also
be turned off.
Use
Use...
19