Charcoal Water Filter
Your coffeemaker comes with a charcoal
water filter that eliminates chlorine, bad
tastes and odors from tap water.
Inserting the Water Filter
• Remove the filter from polybag and soak it,
fully immersed, in cold tap water for 15
minutes.
• Lift the water filter holder out of the water
reservoir.
• Press down on the filter compartment and
pull toward you to open.
• Place filter into the holder and snap it
closed. Be careful – improper placement
can tear the filter skin.
• Flush filter by running
cold tap water through
holes in bottom of
compartment for
10 seconds.
• Allow the filter to drain
completely.
• Slide the water filter holder
back into the channel in the
water reservoir, pushing it
down to the base of the unit
.
NOTE:
We recommend
changing the water filter
every 60 days or after 60
uses, and more often if
you have hard water.
Replacement filters can
be purchased in stores, by
calling Cuisinart Customer
Service, or at
www.cuisinart.com
7
BEFORE BREWING YOUR
FIRST POT OF COFFEE
Rinsing your coffeemaker:
During the
manufacturing process, dust can get trapped
in the unit. We recommend flushing out the
system before brewing your first pot of
coffee. Simply fill the reservoir, power on the
unit, and follow steps 1, 3 and 5 on page 8
under MAKING COFFEE.
Do not add coffee!
PROGRAMMING YOUR
COFFEEMAKER
SETTING THE CLOCK
When the coffeemaker is plugged in, 12:00
will flash in the display for 10 seconds,
indicating the unit is in Clock Set mode. If
12:00 stops flashing, simply press and hold
Hour or Minute button to return to flashing
Clock Set mode.
Setting Hours and Minutes
Press either button to select the desired
time. Hold buttons down to scroll through
the digits quickly, or press and release to
advance one digit at a time. Be sure the PM
indicator is on if setting a PM time.
SETTING THE AUTO ON TIME
1. Press and hold the Prog/Auto On
button for 2 seconds.
The digital display will flash the default
(12:00) or previously selected time.
Follow directions under SETTING THE
CLOCK (above) to program your start-
brew time. Five seconds after finishing,
the unit will automatically exit Auto On
Setup mode and the indicator light will
illuminate, letting you know Auto On is
activated.
NOTE:
To exit Auto On Setup mode, you
can also just press Auto On button again.
2. To activate Auto On using previously
selected time:
Press the Prog/Auto On button.
Previously set time will appear and
indicator will light up. Display will return
to clock setting.
3. To deactivate Auto On:
Press illuminated Auto On button; light
will go off, indicating mode is turned off.
Summary of Contents for PerfecTemp DCC-3200
Page 11: ...11 NOTES...
