9
Exiting Set Program Time Mode
Set Program Time may be exited in any of three
ways:
1. Press the Program Set button again. This
will cause the coffeemaker to revert to its
previous state.
2. Press any other button (except Hour or
Minute). Set Program Time mode will be
exited and the function of the button
pressed will be executed.
3. Do nothing. If neither the Hour nor Minute
button is pressed for a period of five
seconds, the Set Program Time mode will
be exited and the programmed setting will
be in effect.
INSERTING THE WATER
FILTER
a. Remove the filter from polybag and soak in
cold tap water for 15 minutes.
b. Remove the water filter holder from the
coffeemaker by lifting it out of the reservoir
area with your thumb and forefinger.
c. Grasp the stem in one hand. Using the
thumb of the other hand, gently press
down and pull toward you. Compartment
will flip open.
d. Place the filter in the holder and close the
water filter holder; you will hear a snap
indicating filter is in place.
NOTE:
Caution must be used when inserting the
charcoal filter. Improper placement in the holder
can cause tearing of the filter skin.
e. Hold the filter under cold running tap water
for 10 seconds to flush. You should place
the hole openings in the side of the unit
directly under the water stream.
f. Allow the filter to drain completely.
g. Replace the water filter holder in the
reservoir area of the coffeemaker, pushing it
all the way down to the base of the unit,
along the reservoir wall.
NOTE:
We recommend changing the water filter
every 60 days or 60 uses or more often if you
have hard water.
Replacement water filters can be purchased in
stores or by calling customer service or through
the Cuisinart website.
MAKING COFFEE WITH
WHOLE BEANS
Before you make the first pot of coffee in your
new Cuisinart
®
Fully Automatic Burr Grind &
Brew™ Thermal Coffeemaker, we recommend
operating the coffeemaker once, using only
water and a paper filter. This will remove any
dust or residues which will remain in the system
from the manufacturing process. Note: Allow the
grinder to grind free of beans for this process.
1. Fill the Water Reservoir
Open the reservoir lid. Pour the desired
amount of water in the reservoir using the
water level window indicator. Close the
reservoir lid. Note: Do not exceed the
12-cup (1.8 L) line. Doing so may cause the
carafe to overflow.
2.
Add Beans
Lift the hopper lid, using the recess on
either side. Fill the hopper with beans. We
recommend keeping the hopper at least
halfway full. Be sure that you have a
sufficient amount of beans in your hopper
for the amount of coffee you intend to brew
(maximum capacity is ½ lb (250 g)). Over
packing may result in jamming the grinder.
For easy filling, the hopper container can be
taken out by turning the hopper container
release knob to the unlock position.
Note:
Do not put any water in the unit once the
hopper container has been removed. If water
gets into the grinder motor, the motor may
become damaged and may malfunction.
Put hopper lid back in place.
