Cuckoo CMC-Q5 Series, Operating Instructions Manual

Page: 11 / 72

Wipe the inner, upper, and outer parts of the
inner pot of any alien substance. If there is rice water left on the lid, please wipe
it out with a wet towel. The center of the lid is
made out of metal so beware when cleaning.
TOP COVEr
Wipe the top cover with a damp cloth.
Be careful when cleaning the top heater
OVEn PACKInG
This part is designed to gather the moisture
coming through the steam vent during
cooking. Once cooking finished, wipe it clean
with a well wrung dish cloth.
Moisture dish of the main body
In case the cauldron is stained with cooked rice
broth or foreign matter, wipe the cauldron with a
damp dishcloth. Using a rough scouring pad,
brush, or etc. may damage cauldron surface. If
the buttons are not functioning correctly, please
contact our customer care service.
COnTrOL
If there are foreign substances stuck on the
temperature sensor, remove them without
damaging the metal plate. Cleanly wipe the
foreign substances or moist on the heat plate.
InnEr BODY
Wipe the main unit with a damp cloth.
※
Caution
Do not clean the inner pot with any sharp cutlery inside (fork, spoon, chopsticks, etc.).
- The coating of the inner pot may peel off.
MAIn UnIT
Before or after use, please wipe around the Lid
Open button and remove rice water or any
other foreign substances using a wet towel.
Before or after use, if the Lid Open button does
not work, please contact customer service.
LID OPEn BUTTOn
InnEr POT
❶
Separate the dew
dish.
❷
Separate the drain
ditch cap by pushing
it down.
❸
Clean the drain ditch
cap and dew dish with
a neutral detergent.
❹
Securely put in the dew
dish after cleaning
❺
Insert the dew dish
firmly by pressing it in
direction of the arrow.
How to Clean Dew Dish
How to Clean The Pressure Weight Nozzle
•
The valve hole of the pressure weight allows steam to release. Check regularly to ensure that it is not
blocked. If the valve hole of the pressure weight is blocked, the hot steam and hot content within the
cooker can cause serious injury.
※
Do not use the cleaning pin for any other use except to clean the valve hole of the pressure weight.
If the valve hole of the pressure weight part is clogged, puncture it with the cleaning pin
How to
Disassemble the
Pressure Weight
▶
Under the Lock/Unlock handle is the steam cap that guards the pressure weight. To remove the
pressure weight, remove the steam cap, turn the pressure weight counter-clockwise while pulling
it up, and keep turning until it comes out.
▶
Puncture the clogged valve hole with the cleaning pin and reassemble it by turning it clockwise.
▶
When the pressure weight is properly assembled, it can freely be turned.
Soft steam cap
Cleaning Pin
※
Attached on the
bottom of the
unit
Alien
substance
Pressure Weight
a neutral
detergent
11
HOW TO CLEAN
H
O
W
T
O
C
L
E
A
N