Rev. -, p. 10 of 15
11. FRONT VINYL FILLERS
11.1 Fig. 11.1 shows the difference between the left and
right fillers. Install each filler to the bottom inside sur-
face of the front metal cowl and to the inside surface of
the side frame tubing. See figures 11.1.1 and 11.1.2. The
pocket pleats should be facing forward to give pedal
clearance, etc.. Install the supplied PSA hook velcro on
to the tractor at the installer’s discretion (i.e.: on the
floorboard, etc.).
12. REAR FLASHER LIGHTS
12.1 Per fig. 12.1, re-install the flasher light using the
supplied light bracket oriented as shown. Secure the light
bracket to the fender using the following hardware per
side: one 5/16-18 x 3/4” long button head bolt, two steel
washers, and one locknut. Locknut to be underneath the
fender. Orient the bracket so it is outboard and over the
tire as shown (note: white felt was placed over the tire for
photo emphasis on the wiring situation).
12.2 Per fig. 12.1, pass the green wire thru the ring ter-
minal and re-connect the male spade connector to the
female spade connector. Place the ring terminal up on to
the thread on the light and re-install the flat washer, split
washer, and the hex nut. Tighten the nut. Repeat for the
opposite side of the tractor.
12.3 Per fig. 12.3, install the supplied loom over the
exposed wires. Repeat for opposite side of tractor.
Fig. 11.1 (front fillers)
left filler
right filler
Fig. 12.1 (view from right rear side of tractor)
green wire
to pass thru
the ring
terminal
loom
Fig. 12.3 (view from right rear side of tractor)
Fig. 11.1.1 (right side front fillers)
Fig. 11.1.2 (left side front fillers)
vinyl
filler
vinyl
filler
