13
TROUBLESHOOTING - continued
• I
f you encounter any additional difficulties not listed, please contact your local Cub
Cadet dealer.
Symptom
Cause
Solution
No detergent.
Detergent suction tube not
properly connected to the
machine.
Check connection.
Detergent is too thick.
Dilute detergent, for best results
use Cub Cadet detergent.
The filter is closed.
Open the filter by turning it to the
desired detergent intake.
Filter on detergent suction
tube is clogged.
Run warm water through filter to
remove debris.
Damaged or clogged
detergent suction tube.
Remove obstruction or replace
detergent suction tube.
Spray wand is in high
pressure position.
Turn spray wand tip to low pressure
position.
Discharge nozzle is
obstructed.
Blow out or remove debris with a
fine needle.
Garden hose
connection leaks.
Loose fittings.
Tighten fittings.
Missing/worn rubber
washer.
Insert new washer.
Spray wand or Spray
extension wand
leaks.
Spray wand not properly
attached.
Insert the spray wand into the spray
wand extension. Carefully press in
against the spring tension and twist
into the locked position.
Spray wand extension not
properly attached.
Slide the spray wand extension into
the gun. Turn the wand collar
clockwise onto the gun threads until
tight.
Broken o-ring or plastic
insert.
Contact your local Cub Cadet
dealer.
Pump is noisy.
Pump is sucking air.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until
a steady flow of water emerges
through the nozzle.
Water leaks from
pump (up to 10 drops
per minute is
permissible).
Loose fittings.
Check that all fittings are tight.
Thermal protection device
has been activated.
Thermal protection device will
automatically reset.
Water seals are damaged
or worn.
Contact your local Cub Cadet
dealer.
Oil Drip.
Oil seals are damaged or
worn.
Contact your local Cub Cadet
dealer.
