10
s
ectiOn
4— a
sseMbly
& i
nstallatiOn
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
Snap the plastic upper chute support in place by first
1.
clipping the side portion onto the bag support rail with the
edge of the snap feature aligned with the red line (1), as
shown in the inset of Fig. 4-9.
Snap the front portion of the upper chute support to the bag
2.
support rail as seen in 2 of Fig. 4-9.
Install the bagger screen into the bagger cover by first inserting
3.
the end closest to the side with the cutout into the
mounting hole, as in Fig. 4-10. Make sure to feed the screen
under the lip, as in Fig. 4-11.
Clip in the other side by flexing the screen and pushing it
4.
down into the provided cutout hole. See Fig. 4-11.
Install the grass catcher cover onto the bag support assembly, as
5.
seen in Fig. 4-12. The grass catcher cover goes inside of the
two mounting tabs on the bag support assembly.
Slide the hinge pin into the hole located on the mounting tab, as
6.
in Fig. 4-13. Use the cut-out window (See inset in Fig. 4-13)
to line up the hinge pin on the other side and push pin all
the way in until it reaches the end-stop. At this point the
pin clips into place and is secured by a tab in the bagger
cover. See Fig. 4-14.
1
2
Figure 4-9
Figure 4-10
Figure 4-11
Make sure screen sits
under the cover’s lip
