8
5
Figure 5-2
Attaching
Discharge
Chute
&
Bagger
Usage
Figure 5-1
Attaching Discharge Chute
1. Lower the deck to its lowest position.
2. Raise the chute deflector on the deck (A) and hold it
while you position the discharge chute over the chute
opening. See Fig. 5-1.
3. Insert the pin (B) on the discharge chute into the hole
on the deck as indicated by the arrow in Fig. 5-1.
4. Push down on the discharge chute so that it covers
the opening of the deck completely.
5. Lock the discharge chute in position by stretching the
retainer strap over the front deck wheel bracket and
hooking onto the bottom of the bracket as seen in the
inset (D) in Fig. 5-1.
6. Insert the curved end of chute tube into the hole in
the grass bag cover. See Fig. 5-2.
7. Place the lower end of the chute tube over the
discharge chute so that the tabs on the discharge
chute fits into the pockets on the chute tube. See Fig.
5-3.
8. Secure by hooking the two retainer straps of the
discharge chute to the pins on the chute tube. See
Fig. 5-3.
Bagger Usage
NOTE: When both grass bags are full, place the tractor
on a firm, level surface, disengage the PTO, turn the
tractor engine off and set the parking brake.
1. Flip Seat up.
2. Lift up grass bag cover. Do not remove the chute
tube assembly from the tractor.
3. Remove the grass bags by lifting these up and mov-
ing the bags away from the support tube assembly.
4. Empty the grass clippings at a proper disposal sight,
use the handle at the bottom of each grass bag.
Holding the bag firmly, empty the contents
5. Replace grass bags, close lid, flip down seat, restart
your tractor and resume cutting your grass.
Figure 5-3
Tab
A
B
D
C