17
•
Reassemble the new friction wheel rubber to the
friction wheel assembly, tightening the six screws in
rotation and with equal force. It is important to
assemble the rubber on the friction wheel
symmetrically for proper functioning.
Figure 24
•
Insert the pin from the shift arm assembly into the
friction wheel assembly and hold assembly in
position. Refer to Figure 23.
•
Slide the hex shaft through the left side of the
housing and through the friction wheel assembly.
•
Insert the hex shaft through the sprocket and the
spacer. Make certain that the chain engages both
the large and the small sprocket.
NOTE:
If the sprocket fell from the snow thrower while
removing the hex shaft, place the sprocket on the hex
shaft. Position the hex hub of the sprocket toward the
friction wheel when sliding the sprocket on to the hex
shaft as shown in Figure 25.
Figure 25
•
Secure with the bell washer and hex bolt removed
earlier.
•
Secure the frame cover with six self-tapping
screws. Put the snow thrower down to its normal
operating position.
NOTE:
If you placed plastic film under the gas cap, be
certain to remove it.
Engine
Refer to separate engine manual for all engine
maintenance procedures.
SECTION 8: OFF-SEASON STORAGE
WARNING:
Never store engine with fuel in
tank indoors or in poorly ventilated areas,
where fuel fumes may reach an open flame,
spark or pilot light as on a furnace, water
heater, clothes dryer or other gas appliance.
•
If unit is to be stored over 30 days, prepare engine
for storage as instructed in the engine manual.
•
Remove all debris from the exterior of equipment.
•
Follow lubrication recommendations on page 12.
•
Always store the snow thrower in a clean, dry area.
NOTE:
When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust proof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings and cables.
Friction Wheel Plates
Screws
Friction Wheel
Rubber
Hub
Bearing
Shift Arm
Assembly
Pin
Friction
Wheel
Sprocket
Spacer
Sprocket
Hex Hub
of Sprocket
Hex
Shaft
Spacer
