IP address
Normally the IP address will be found by interrogating the router. If this is not
possible you can download this program which will tell you the IP address:
https://www.lantronix.com/products/deviceinstaller/
Install the program, run it and it will auto search. If not just press search.
If you want to fix the IP address double click on the name it found (XPort-NN)
Then select web configuration, then press the right green arrow.
When it asks user name and password just click ok.
Select network and you will see configuration settings. Select ‘use the following IP
configuration’.
Type in your required IP address and mask.
Select OK at the bottom of the page.
Select apply settings on the left. It will take a minute or so to save the settings and
will tell you when it’s done.
Power cycle the unit and it will use the IP address you typed in.
Be careful about some of the other settings you can access, there are many of them
that can stop the unit operating correctly.
Updating
When firmware updates are available, they may be downloaded from:
https://www.ctpsystems.co.uk/support.html
and programmed using our firmware update manager available on the same page.
Full instructions will be supplied with the update.
Audio Outputs
Audio outputs are available as analogue, AES and embedded.
Connect a video SDI/HD-SDI source to SDI In. The unit will embed the four audio
channels to channels 1-4 respectively of the SDI signal. Any other audio embedded
channels will just pass through. Connect to SDI Out for your embedded signal.
The four analogue outputs are available on the D25 connector on the rear as are the
AES audio signals. The AES sample rate is 48kHz.
