CTP Systems CTPhone 1900, Applications Manual

Page: 81 / 132

DOC00101-01 4-7
CTPhone 1900 System Configuration
Table 4-A. System Settings
Parameter Description
Units/
Range
Recom-
mended
Setting
Your
Setting
System ID ID for this CTPhone 1900 system.
Handsets must be programmed with
this ID to operate in this system. The ID
for your system is written on a label on
the CTPhone Controller. n.a. ID shown
on Control-
ler label
Base Station 1 ID ID of the first base station connected to
this CTPhone Controller. 0–31
Base Station 2 ID ID of the second base station con-
nected to this CTPhone Controller. 0–31
Stop Ringing Time Length of time the CTPhone Controller
waits after last detection of ring voltage
on a line before concluding ringing has
stopped. 100 ms
1
1
For example, a setting of 2 means 2 x 100 ms or 200 ms.
45
Dial Tone Delay Length of delay between a user press-
ing CALL key and receiving dial tone.
The delay may be necessary to elimi-
nate the possibility of a user dialing
before the office telephone system is
ready. 100 ms
1
2
DTMF Cycle Duration Duration of the full DTMF cycle (length
of tone plus length of silence between
tones) used to perform dialing and other
telephone system operations.
10 ms
2
20
DTMF Off Duration Duration of silence between DTMF
tones. 10 ms
2
2
For example, a setting of 2 means 2 x 10 ms or 20 ms.
10
Hook Flash Duration Duration of the hookflash used to signal
the office telephone system. 100 ms
1
5
FT Pause Duration Duration of pause events in Feature
Table. 100 ms
1
10
FT Inter-Event Pause Duration of pause between events in
Feature Table.
100 ms
1
1
Second BS Service
Enabled TRUE if this CTPhone Controller pro-
vides service for a second base station;
FALSE if it doesn’t or the second base
station is out of order. n.a.