CTP Systems CTPhone 1900, Applications Manual

Page: 79 / 132

DOC00101-01 4-5
CTPhone 1900 System Configuration
Recommended Configuration Method
Before making changes or adding information to configuration databases,
the recommended method is:
1 Get the current configuration from the CTPhone Controller.
2 Save the current configuration to a file on the PC.
3 Open and edit a copy of the current configuration on the PC.
4 Send the new configuration to the CTPhone Controller.
Using this method ensures that you retain a copy of the current configura-
tion and that you edit (add to or change) existing data.
Caution Sending configuration information to the CTPhone Controller
overwrites existing information on the CTPhone Controller. You must make
sure the configuration you are sending contains all required configuration
information, not just the few additions or changes you wish to put into
effect.
Required Configuration Information
System Settings Table
Table 4-A on page 4-7 provides a table you can use to collect configuration
data for system parameters. The table also describes each system param-
eter.
Note You have already configured this table as part of the software instal-
lation process. However, at this time, you may want to make some
changes to your initial settings.
CTPhone Extensions – User Table
Table 4-B on page 4-8 provides a table you can use to collect configuration
data for CTPhone extensions. The extension number is the extension
number configured in the office telephone system; see Table 4-D on
page 4-10 for an explanation of handset ID.
Note Even though the table shows all 32 lines, you should only configure
as many extensions as your CTPhone Controller will support (8, 16, 24, or
32).