CTP Systems CTPhone 1900, Applications Manual

Page: 46 / 132

2-18 DOC00101-01
CTPhone 1900 System Planning
Stand-Alone (Test) Base Station
After considering your site layout, possible obstructions (walls, doors,
large metal objects), traffic patterns, and number of handset users, you will
have a good idea of where you need to mount your base stations for opti-
mum coverage at your site. Before you permanently mount your base sta-
tions, it is recommended that you test the proposed base station locations
with a stand alone base station used as follows:
Stand-Alone Base Station Operating Instructions
Required Equipment:
1 CTPhone Stand-Alone (Test) Base Station
2 CTPhone Base Station power supply with cord
3 One or more CTPhone handsets with fully charged batteries
4 Floor plan of the facility that you are surveying
+
Stand-Alone Base Station Set-Up
Step Procedure
1 Determine the best location for a base station using the
guidelines described in this chapter.
2 Temporarily mount the Stand-Alone Base Station as closely
as possible to the selected base station location with appro-
priate vertical and horizontal orientation.
Note When mounting horizontally, rotate all four antennas to
a 90° angle.
3 Plug the base station power supply into the +5 VDC connec-
tor on the bottom of the Stand-Alone Base Station and into a
110 VAC outlet.
4 Observe the LEDs on front of the Stand-Alone Base Station
until all red LEDs are off and only the green LED is on.
+
Handset Set-Up
Step Procedure
1 Make sure that your handsets are fully charged.
2 Press to turn on the handset
PWR