CANAM TECHNOLOGY, INC. (CTI)
MARK-IVD 800MHZ NARROWBAND SIGNAL BOOSTER M4DBDA8 USER’S MANUAL
Page 9 of 13
Rev1 May/2015
Section D.
START - UP
D.1
ACCESSING D.U.T. WEB SERVER
The system can be connected to a PC computer using an Ethernet crossover
cable or to LAN using an Ethernet straight cable.
D.1.1 Connect D.U.T to P.C computer using a crossover cable
Figure 3 – D.U.T. connected directly to PC computer.
1.
Use an Ethernet crossover cable for connect equipment directly to a
PC computer LAN port (refer to Item #8 in Figure 2).
2.
The IP address of the equipment is shown in the LCD display. By default
it is 192.168.100.75 with Network Mask = 255.255.255.0.
o
To verify IP address press the Down key in LCD Display and
Keypad assembly until get IP ADDRESS value.
3.
Configure the local computer IP address to allow access to the
controller, within the same sub-net.
o
Go to “Star >> Control Panel >>Network Settings”.
o
Right-Click on the “Local Area Connection” and choose
“Properties”.
o
Look for “Internet Protocol” and click “Properties”.
o
Select “Use the following IP Address”.
Configure PC computer IP address as 192.168.100.X (X is a
value between 0-255) with Network Mask = 255.255.255.0.
