P2 - P5 PowerStations: DRAM Replacement
6
CTC Parker Automation
Removing a DRAM Module
Follow these instructions to remove a DRAM module from the CPU card.
1. Locate the DRAM socket(s) on your PowerStation. On the P2, P3 and
P5 PowerStations, the DRAM slots are located in a similar position as
the DRAM slots on the P4 PowerStation shown below.
2. Push outward on the two clips holding the DRAM module in its socket
as shown below. You may need to use a small screwdriver or the tip of
a pen to push on the clips.
Note
If only one DRAM module is required, it can be installed in either
socket.
DRAM Sockets
Clip
DRAM
