46
CHAPTER 3
INTRODUCTION TO CLI
3.9.3.3 (config)# access-list rate-limiter
Syntax:
(config)# access-list rate-limiter [ <rate_limiter_list> ] { pps <pps_rate> | 100pps <pps100_rate> | kpps
<kpps_rate> | 100kbps <kpbs100_rate> }
Explanation:
Configure rate limiter that applies to each rate limit ID.
Parameters:
[ <rate_limiter_list> ]: Specify the “rate limit ID”, “100kbps” or “pps” . The allowed rate limit ID range is from1~16.
{ pps <pps_rate> | 100pps <pps100_rate> | kpps <kpps_rate> | 100kbps <kpbs100_rate> }: Specify the rate limit
rate.
Show:
# show access-list rate-limiter [<RateLimiterList : 1~16>]
3.9.3.4 (config-if)# access-list action
Syntax:
(config-if)# access-list action { permit|deny}
Explanation:
Configure a specific port’s action option.
Parameters:
{ permit|deny}: Permit or deny frames on a specific port.
Show:
# show access-list [ interface [ ( <port_type> [ <v_port_type_list> ] ) ] ]
3.9.3.5 (config-if)# access-list logging
Syntax:
(config-if)# access-list logging
Explanation:
Enable a specific port’s logging function.
Show:
# show access-list [ interface [ ( <port_type> [ <v_port_type_list> ] ) ] ]
Negation:
(config-if)# no access-list logging
3.9.3.6 (config-if)# access-list policy
Syntax:
(config-if)# access-list policy <policy_id>
Parameters:
<policy_id:0-255>: Specify a policy ID that applies to this specific port.
Explanation:
Apply a policy ID to a specific port.
Show:
# show access-list [ interface [ ( <port_type> [ <v_port_type_list> ] ) ] ]
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
