Chapter 4. Web Configuration & Operation
348
CHAPTER 4
WEB OPERATION & CONFIGURATION
indicated that the limit is exceeded. No MAC addresses can be learned on the port until it is administratively re-
opened on the Limit Control configuration page.
MAC Count (Current/Limit):
The two columns indicate the number of currently learned MAC addresses (forwarding as
well as blocked) and the maximum number of MAC addresses that can be learned on the port, respectively. If no user
modules are enabled on the port, the Current column will show a dash (-). If the Limit Control user module is not
enabled on the port, the Limit column will show a dash (-).
4.4.5.2.1.2 Port Status
This page shows MAC addresses learned on a particular port.
MAC Address:
When “Port Security Limit Control” is enabled globally and on a port, MAC addresses learned on a port
show in here.
VLAN ID:
Display VLAN ID that is seen on this port.
State:
Display whether the corresponding MAC address is forwarding or blocked. In the blocked state, it will not be
allowed to transmit or receive traffic.
Time of Addition:
Display the date and time when this MAC address was seen on the port.
Age/Hold:
If at least one user module has decided to block this MAC address, it will stay in the blocked state until the
hold time (measured in seconds) expires. If all user modules have decided to allow this MAC address to forward, and
aging is enabled, the Port Security module will periodically check that this MAC address is still forwarding traffic. If the
age period (measured in seconds) expires and no frames have been seen, the MAC address will be removed from the
MAC table. Otherwise a new age period will begin. If aging is disabled or a user module has decided to hold the MAC
address indefinitely, a dash (-) will be shown.
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
