172
CHAPTER 3
INTRODUCTION TO CLI
<v_ipv6_ucast>: Specify the IPv6 address. It allows a valid IP address in dotted decimal notation ('x.y.z.w'). Also
allowed is a valid hostname. A valid hostname is a string drawn from the alphabet (A-Z; a-z), digits (0-9), dot (.)
and dash (-). Spaces are not allowed. The first character must be an alpha character, and the first and last
characters cannot be a dot or a dash.
[ <udp_port> ]: Indicates the SNMP trap destination port. SNMP Agent will send SNMP message via this port, the
port range is 1~65535. The default SNMP trap port is 162.
[ traps | informs ]: Specify one of the options.
Negation:
(config-snmps-host)# no host
3.9.44.16 (config-snmps-host)# host <v_ipv4_ucast>
Syntax:
(config-snmps-host)# host { <v_ipv4_ucast> | <v_word45> } [ <udp_port> ] [ traps | informs ]
Explanation:
Configure the SNMP trap destination IPv4 address.
Parameters:
{ <v_ipv4_ucast> | <v_word45> }: Indicates the SNMP trap destination address. It allows a valid IP address in
dotted decimal notation ('x.y.z.w'). Also allowed is a valid hostname. A valid hostname is a string drawn from the
alphabet (A-Z; a-z), digits (0-9), dot (.) and dash (-). Spaces are not allowed. The first character must be an alpha
character, and the first and last characters cannot be a dot or a dash.
[ <udp_port> ]: Indicates the SNMP trap destination port. SNMP Agent will send SNMP message via this port, the
port range is 1~65535. The default SNMP trap port is 162.
[ traps | informs ]: Specify one of the options.
Negation:
(config-snmps-host)# no host
3.9.44.17 (config-snmps-host)# version
Syntax:
(config-snmps-host)# version { v1 [ <v1_comm> ] | v2 [ <v2_comm> ] | v3 [ probe | engineID
<v_word10_to_32> ] [ <securtyname> ] }
Parameters:
{ v1 [ <v1_comm> ] | v2 [ <v2_comm> ] | v3 [ probe | engineID <v_word10_to_32> ] [ <securtyname> ] }: Specify
one of the SNMP versions.
v1 [v1_comm]:
Support SNMPv1 and trap community access string when sending SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is ASCII characters from 0x21 to 0x7E.
v2 [v2_comm]:
Support SNMPv2c and trap community access string when sending SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is ASCII characters from 0x21 to 0x7E.
v3 [ probe | engineID <v_word10_to_32> ] [ <securtyname> ]:
Support SNMPv3.
[ probe | engineID <v_word10_to_32> ]:
Indicates the SNMP trap probe security engine ID or SNMP
trap security engine ID. SNMPv3 sends traps and informs use USM for authentication and privacy. A
unique engine ID for these traps and informs is needed. When "Trap Probe Security Engine ID" is
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
