132
CHAPTER 3
INTRODUCTION TO CLI
<inst>: Specify an instance ID number.
<vid>: The MEP VID value.
Negation:
(config)# no mep <inst> vid
Show:
# show mep [ <inst> ] [ peer | cc | lm | dm | lt | lb | tst | aps | client | ais | lck ] [ detail ]
3.9.32.24 (config)# mep <inst> voe
Syntax:
(config)# mep <inst> voe
Explanation:
MEP is VOE based.
Parameters:
<inst>: Specify an instance ID number.
Negation:
(config)# no mep <inst> voe
Show:
# show mep [ <inst> ] [ peer | cc | lm | dm | lt | lb | tst | aps | client | ais | lck ] [ detail ]
3.9.33 (config)# monitor
3.9.33.1 (config)# monitor destination interface
Syntax:
(config)# monitor destination interface <port_type> <in_port_type>
Explanation:
Configure which port traffic should be mirrored to.
Parameters:
<port_type>: Specify the interface type.
<in_port_type>: Specify the port number.
Example:
Set the traffic to be mirrored to Gigabit Ethernet port 10.
Negation:
(config)# no monitor destination
3.9.33.2 (config)# monitor source
Syntax:
(config)# monitor source{ [ interface ( <port_type>) [ <v_port_type_list> ] ]} | { cpu [ <cpu_switch_range> ] }
{ both | rx | tx }
Explanation:
Configure which source ports’ RX or TX traffic should be mirrored to the destination port.
Parameters:
# config t
(config)# monitor destination interface gigabitethernet 1/10
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
