CTC Union ET100/NRZ, User Manual

Page: 13 / 20

ET100/NRZ LAN-WAN Bridge
13
1.6 DIP Switch Setting Tables:
When the ET100/NRZ is set to internal clock (SW3 3&4 OFF), then SW2-1 to SW2-5 may be used to
configure the data rate and TX Timing signal's speed. If SW3 3 is ON and 4 is OFF, then all SW2-1 to
SW2-5 are ignored and the unit operates by recovering the clock from the NRZ's RX Timing. SW2 3&4
OFF is the normal mode for connecting to existing NRZ that supplies clocking. In this mode the TX
Timing signal is the loop back timing from the RX Timing signal.
1.6.1 Data Rate Settings:
SW2 SW STATE Function
-1 -2 -3 -4 -5 Bit rate setting
OFF OFF OFF OFF OFF 64K
ON OFF OFF OFF OFF 128K
OFF ON OFF OFF OFF 192K
ON ON OFF OFF OFF 256K
OFF OFF ON OFF OFF 320K
ON OFF ON OFF OFF 384K
OFF ON ON OFF OFF 448K
ON ON ON OFF OFF 512K
OFF OFF OFF ON OFF 576K
ON OFF OFF ON OFF 640K
OFF ON OFF ON OFF 704K
ON ON OFF ON OFF 768K
OFF OFF ON ON OFF 832K
ON OFF ON ON OFF 896K
OFF ON ON ON OFF 960K
ON ON ON ON OFF 1024K
OFF OFF OFF OFF ON 1088K
ON OFF OFF OFF ON 1152K
OFF ON OFF OFF ON 1216K
ON ON OFF OFF ON 1280K
OFF OFF ON OFF ON 1344K
ON OFF ON OFF ON 1408K
OFF ON ON OFF ON 1472K
ON ON ON OFF ON 1536K
OFF OFF OFF ON ON 1600K
ON OFF OFF ON ON 1664K
OFF ON OFF ON ON 1728K
ON ON OFF ON ON 1792K
OFF OFF ON ON ON 1856K
ON OFF ON ON ON 1920K
OFF ON ON ON ON 1984K
-1,-2,-3,-4,-5
ON ON ON ON ON 2048K
-6,-7,-8 Reserved
Table 1: DIP settings for Data Rate.