CANedge2 Docs, Release FW 01.04.02
0.4.6.6 Checksum
Supports LIN 1.3
classic
checksum and LIN 2.0
enhanced
checksum format. By default, all frames except
ID 0x3C and 0x3D will use enhanced checksum. This can be overridden in the configuration for each
frame ID.
0.4.7 Connect
This page documents the
Connect
configuration.
The Connection configuration is split into the following sections:
0.4.7.1 WiFi
This page documents the
wifi
configuration
Configuration file fields
This section is autogenerated from the Rule Schema file.
Error:
Unable to execute python code at wifi.rst:14:
‘NoneType’ object is not iterable
Configuration explained
This section contains additional information and examples.
Multiple WiFi access points
The device supports multiple access points. The device will attempt to connect to the access points in
the prioritized order in which they are entered in the configuration file. If unable to connect to an access
point or if the signal strength is below the minimum RSSI%, the device will attempt the next one from
the list. Every time the device initiates a new WiFi connection, it will cycle through the list in this
manner, starting from the top.
Using an RSSI% of 0 (default) means that the device will attempt to connect to the AP, even if the
signal strength is practically non-existent.
0.4.7.2 S3 server
This page documents the
s3 server
configuration
Note:
If a HTTPS (TLS) server
Endpoint
is used, refer to the
for more information
on how to setup certificates.
44
CONTENTS
