HV DTemp Measurement System – Using a HV DTemp Measurement System
User Guide
33
Version 01.00 // 2021
Enter the serial number (
S/N
) of the HV DTemp-P central unit if available.
Click on
OK
to close the window.
⇨
The structural elements
DTemp_P System
,
CAN Identifer
and
DTemp_M Modules
are
displayed in the right window section.
⇨
A yellow warning symbol indicates that there is no online connection to the central unit.
Fig. 5-11: DTEMPconfig: Central unit inserted into the configuration
Inserting a controller
The controller(s) required for the configuration are inserted in the
DTemp_M Modules
section ('No modules yet' is displayed there so far).
Fig. 5-12: Inserting a controller
Select
+M64
(or
+M16
) in the
DTemp_M Modules
section.
⇨
A table for a corresponding HV DTemp-M controller is inserted.
Fig. 5-13: Controller inserted into the configuration
The fields for the ID (
#
) and the serial number (
S/N
) display '0' or, as with the central unit,
a yellow warning symbol. This symbol indicates that there is no online connection.
Click on the blue bar or the
button, to expand the table. This table provides the
means to configure the sensors individually.
⇨
The table is faded in.
Fig. 5-14: Expanded controller table
Make the required settings.
⇨
Select
Save As
to save the configuration document.
→ See also section "Transferring the configuration data to the module".
