HV DTemp Measurement System – Using a HV DTemp Measurement System
User Guide
42
Version 01.00 // 2021
5 3 2 5 Sending and saving configuration data
At module level, the context menu contains, among others, the following commands:
f
Read settings from device
reads the configuration from a central unit. The firmware
version and the hardware revision number are also read out.
f
Write settings to device
writes the configuration that is currently active in DTEMPconfig
to a central unit.
Transferring the configuration data to the module
When the configuration of the central unit and the controller(s) has been completed, the
data must finally be transferred to the central unit.
NOTE!
i
This step is required for offline and online configurations.
Right-click on the device entry.
⇨
The context menu opens.
Fig. 5-31: Context menu, module level:
Write settings to device
Select
Write settings to device
⇨
The following message is displayed:
Fig. 5-32: Safety prompt before overwriting the old configuration
Click
OK
to write the configuration to the device.
⇨
A message indicates the successful reconfiguration of the central unit.
or
Click
Cancel
to keep the old configuration.
Reading configuration data from the central unit
Select
Read settings from device
in order to load a configuration that is stored in a
central unit into the configuration document.
Saving the configuration
The configuration must finally be saved. The default path for storing configuration files
refers to the DTEMPconfig installation directory. If user rights are restricted, the program
prompts the user to save the file in the corresponding user directory.
