Right
Left
Installation Instructions
Note:
When grounding equipment, ensure that
you use a good earth ground. Otherwise,
operational errors may occur.
1. Ensure power is disconnected from the
I/STAT-LCD and from all devices that will
be connected to the I/STAT-LCD.
Warning:
Failure to disconnect power from all
interconnected equipment when per-
forming electrical installation may result
in electrical shock or burns.
2. Mount the I/STAT-LCD base to a wall-
mounted, standard electrical utility box
no more than 100 feet (30 m) from the
controller.
3. Connect a 22-AWG (0.324 mm
2
),
shielded, twisted-pair cable (Belden 9184)
from the controller’s I/STAT port to ter-
minal block TB1 on the I/STAT-LCD as
follows:
a. Connect the DATA wire from the con-
The following figure shows the I/STAT-LCD,
its dimensions, its mounting-hole locations,
and the electrical connections required to
connect it to a controller.
2.75"
(6.98 cm)
Front
Back
4.50"
TB1
1
2
3
DATA
+12 VDC
GROUND
1
2
3
TB1
TBx
I/STAT-LCD
MR, ASC, 7728,
or NetPoint device
2.38"
2.38"
2.38"
(6.03 cm)
(6.03 cm)
(6.03 cm)
(8.38 cm)
(8.38 cm)
(8.38 cm)
3.30"
3.30"
3.30"
0.60" (1.52 cm)
0.60" (1.52 cm)
0.60" (1.52 cm)
0.60" (1.52 cm)
0.60" (1.52 cm)
0.60" (1.52 cm)
(11.43 cm)
(11.43 cm)
(11.43 cm)
