CSI City Softener MSC32-S2, Installation & Operation Manual

Page: 13 / 32

13
Master Programming Mode
Master Programming Mode
To enter Master Programming Mode, press and hold both buttons for 5 seconds.
Note: All Master Programming functions have been preset at the factory. Unless a change is desired, it is
NOT
necessary to enter Master Programming Mode.
1. Regeneration Time ( r )
Example [ r 2A ]
- The time of day at which regeneration may take place is designated by the letter “ r ”.
- Default regeneration time setting for
SOFTENERS is 2a
- The first display digit indicates A.M. or P.M. To change the value, press the
Set/Change
button.
- Press
Menu/Enter
button to accept the value and move to the next digit.
- The second and third display digits indicate the hour at which the regeneration will occur.
- Change the digits with the
Set/Change
button and accept with the
Menu/Enter
button.
- After the entire display flashes, press the
Menu/Enter
button to move to the next menu item.
2.
Regeneration Day Override (A)
- Press
Menu/Enter
button. This display is used to set the maximum amount of time (in days) the unit can be in
service without regeneration. This setting is identified by the letter “A” in the left digit. Regeneration will begin at
the scheduled time. A setting of zero will cancel this feature.
- Example: Override every 7 days ( A-07 ), default setting, or cancel setting ( A-00 ). Maximum is 29.
3.
Regeneration Cycle Step Times (Steps 1, 2, 3, 4)
Example [ 3 - 10 ]
- The next 4 displays set the duration of time in minutes for each regeneration cycle step.
- The step number which is currently modifiable is indicated on the far left of the display screen.
- The number of minutes allotted for the selected backwash step is displayed on the far right.
- Change the digit values using the
Set/Change
and
Menu/Enter
buttons as described above.
4.
System Capacity in Grains
( c ) – Meter (Demand Mode Only)
- Press the
Menu/Enter
button. This display is used to set the system capacity in grains and is used in
conjunction with the hardness setting to calculate total gallons of treated water available between regenerations.
This option is identified by the letter “c” in the left digit. The maximum value for this item is 399. Example: 32,000
grain capacity ( c 032 ).
5.
Reserve Capacity Setting
% Example (p - 25)
6.
Bluetooth Enabled
BE - 1 (ON)
BE - 0 (OFF)
7.
Bluetooth Password
BBPP is displayed for one second, then password is displayed.
8. To Exit the Master Programming Mode, press the
Menu/Enter
button until time of day returns.
Note
: If no buttons are pressed for 60 seconds, the Master Programming Mode will be exited automatically.